1G Fiber Pro AV Over IP Encoder - HDMI Ethernet And USB

Frame rate2

24, 25, 30, 50, or 60 fps

Chroma sampling2

4:4:4, 4:2:2, or 4:2:0

Color bit depth2

8, or 10 bits per color

Signal Type

DVI v 1.0, HDMI v1.4 and v2.0, HDCP v1.4 and v2.3

Max. video data rate

18 Gbps (6 Gbps per color)

Number/signal type

1 digital HDMI video*
1 digital HDMI video (loop through)

Connectors

2 female HDMI type A: 1 for input, 1 for loop through

Resolution range

Up to 4K (4096x2160 at 60 Hz) and UHD (3840x2160 at 60 Hz)

Standards

DVI v1.0, HDMI v1.4 and v2.0, HDCP v1.4/v2.3

Digital sampling

8 or 10 bits per color; 600 MHz pixel clock maximum

Compression

PURE3

Bit rate

250 Mbps to 900 Mbps

Latency

<1 frame (encode/decode)**

Number/signal type

1 PURE3 digital video over IP

Connector

1 SFP connector (SM or MM)

Gain

Analog to Analog: -6.5dBu balanced, -12.5 unbalanced
HDMI to Analog: -5.3dBu balanced, -11.3 unbalanced

Frequency response

20 Hz to 20 kHz, +0.5 dB

THD + Noise

<0.1% @ 20 Hz to 20 kHz at nominal level

S/N

Analog to Digital: >90dB, at Full scale output, unweighted
Digital to Analog: >90dB, at Maximum balanced output, unweighted
Analog to Analog: >90dB, at Maximum balanced output, unweighted

Crosstalk

<-80 dB @ 1 kHz, fully loaded

Stereo channel separation

>80 dB @ 1 kHz

Sampling Rates

32, 44.1, 48 kHz

Bit depths

16, 20, 24 bit

Number/signal type

1 analog stereo, unbalanced or balanced
1 digital stereo, de-embedded from HDMI

Connectors

(1) 3.5 mm captive screw connector, 5 pole
1 female HDMI type A (shared with video input)

Supported formats

LPCM (2 channel), analog stereo audio

Impedance

>10 kohms unbalanced, >20 kohms balanced

Nominal level

+4 dBu, -10 dBV configurable

Maximum level

+21 dBu balanced, +15 dBu unbalanced

Gain adjustment range

Adjustable, -18 dB to +10 dB

Number/signal type

1 audio over IP LPCM
1 audio over IP AES67*

Connector

1 SFP connector (SM or MM)

Number/type

2 fiber optic

Connector type

(1) 1G SFP connector (SM or MM), supporting 2 LC fiber connectors

Ethernet standards

1GbE (802.3z), 1000 Base-LX (SFP) SM, 1000 Base-SX (SFP) MM

Termination

MDI (SFP)

Protocols

Streaming

SRTP (AES-128) on video, audio, and USB

Transport

Multicast UDP

All supported

DHCP, HTTPS, IGMPv2/v3, IPv4, PTPv2, QoS, SSH, TCP, UDP

Security

AES-256, 802.1x, Active Directory authentication

Signal transmission distance

Singlemode

1000Base-LX (SFP) SM - up to 10km (6.25 miles)

Multimode

1000Base-SX (SFP) MM - up to 550m (1804 feet)

Nominal peak wavelength

850 nm for multimode, 1310 nm for singlemode

Transmission power

Singlemode

-7.6 dBm, minimum

Multimode

-8.1 dBm, minimum

Maximum receiver sensitivity

Singlemode

-19.0 dBm, maximum

Multimode

-18.0 dBm, maximum

Optical loss budget

Singlemode

11.4 dB, maximum

Multimode

9.9 dB, maximum

Connector

1 RJ-45 female

Termination

Auto-MDIX, TIA/EIA T568B

Ethernet standards

1Gbps (802.3ab), 10/100/1000 Base-T, half/full duplex with autodetect

Signal transmission distance

330' (100 m) using CAT-5e/6/6a/7 cables

USB device port Host mode configuration (default mode)

Number/signal type

1 USB 2.0 high speed

Connector

1 USB type C female

Power

N/A

Maximum built-in USB hubs

1

Minimum built-in USB hubs

0

Optional built-in USB hubs

1 (peripheral emulation enabled)

USB device port configuration Device mode configuration

Number/signal type

1 USB 2.0 high speed

Connector

1 USB type C female

Power

5V DC, 500mA (when in device mode)

Maximum built-in USB hubs

0

Minimum built-in USB hubs

0

Optional built-in USB hubs

0

Host support

xHCI (USB 3.0), EHCI (USB 2.0), OHCI/UHCI (USB 1.1)

Data rates

Low speed (1.5 Mbps), full speed (12 Mbps), high speed (480 Mbps)

Traffic types

Bulk, control, interrupt, and isochronous

Network switch hops

5 hops (typical)

Serial

Quantity/type

1 bidirectional RS-232

Connector

(1) 3.5 mm captive screw connector, 5 pole (shared with IR port)

Baud rate and protocol

300 to 115200 baud (9600 baud = default)
8 (default) or 7 data bits
1 (default) or 2 stop bits
no parity (default), even or odd parity

Pin configuration

Tx, Rx, and Gnd

IR control

Quantity/type

1 TTL level (0 to 5 V) infrared (carrier and non-carrier) up to 300 kHz

Connector

(1) 3.5 mm captive screw connector, 5-pole (shared with RS-232)

Pin configuration

S = signal and G = Gnd

IR output carrier frequency

30 kHz to 300 kHz

CEC control

1 HDMI type A loop through connector

Contact closure

Quantity/type

1 contact closure input

Connector

(1) 3.5 mm captive screw connector, 2 pole (shared with tally)

Input voltage range

0 to 5 VDC, clamped at +5.1 VDC

Pin configuration

C = contact input (+5 VDC) (Ground is supplied by HDMI connector on an Extron Show-Me cable)

Tally port

Quantity/type

1 tally output

Connector

(1) 3.5 mm captive screw connector, 2 pole (shared with contact closure)

Pin configuration

T = tally output (GND) (+5 VDC is supplied by HDMI connector on an Extron Show-Me cable)

USB configuration port

Quantity/type

1 front panel USB mini-B

Standard

Ethernet over USB

Power supply

External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 2.0 A, 24 watts

Power consumption

Device

23.9 watts

Device and power supply

27.0 watts

Ambient temperature/humidity

Storage: -40 to +158 F (-40 to +70 C) / 10% to 90%, noncondensing
Operating: +32 to +104 F (0 to +40 C) / 10% to 85%, noncondensing

Cooling

Fan, air flows from top to rear

Thermal dissipation

Device

72.1 BTU/hr

Device and power supply

82.8 BTU/hr

Mounting

Rack mount

Yes, with optional rack shelf

Furniture mount

Yes, with optional under desk mounting kit

Enclosure type

Metal

Enclosure

1.00" H x 8.75" W x 6.00" D (half rack wide)
(25 mm H x 222 mm W x 152 mm D)

Product weight

1.5 lbs (0.68 kg)

Regulatory compliance

CE, c-UL UL,C-tick, FCC Class A, ICES, VCCI,
Complies with the appropriate requirements of RoHS, WEEE

Product warranty

3 years parts and labor

Everlast power supply warranty

7 years parts and labor